With one length fitted to the door and one to the frame, a reliable, long-lasting, 'magnet-to-magnet' closure is achieved time after time. The same profile can be used for the door and the frame as we denote the NORTH pole with an identifying groove.

A typical profile shape is a ‘T' as shown below:


Extruded in flexible isotropic ferrite this magnetic principle is an inexpensive and a totally permanent magnetic solution. Over half of our 450 extrusion tools are shaped for shower door closures.

If you have a completely new design then that is not an issue to us. We have the ability, from a supplied engineering drawing, to put down a new die and run test samples within 10 working days.

These profiles can be supplied in rolls or cut lengths depending on the geometry of the profile.